What is the best in the porcelane brick, the best Shanghai decoration master share how to use tile rubber

0 Comments

Tiles will be used in the decoration to stick to the tiles, but now the lane tile glue is now too much, let people be dazzled, let’s take a look at it.

What kind of glue is best for stick porcelane bricks

And the use of tile rubber.

The adhesive strength of the tile rubber is several times that of cement mortar, so it is widely used in various wall tiles. What glue is the most strong? The following three adhesive tiles are very good.

1, debris acid type glue

The greatest feature of debrise has a good transparency, fast vulcanization, and easy to release acetic acid and pungent smell during curing, and also has strong corrosive resistance to coating glass, metal and some inorganic materials.

2, desisted gel

粘瓷砖用什么胶最好 上海装修师傅分享怎么使用瓷砖胶

The dehydric type wall adhesive shrinkage is small, and the degree of soaking water will be slow. Most raw materials have corrosive, and the adhesiveness of materials such as marble and plastic steel is poor. And use at high temperatures when used, and it is also easy to form small bubbles, which will directly affect the quality of the brick.

3, deacid gelatin

Deacidized wall adhesive cannot be used for cement, stone, etc., because acid glue is easy to form acetic acid, easy to react with the surface of the alkaline material such as cement, stone, and the expansion coefficient is large, fitted It is too thin that the surface will cause a wrinkle, which affects the overall beauty.

Type ceramic brick glue

1, prepare tool

Before construction, we need to prepare the materials you need to ensure smooth construction. The specific tools are as follows: tile rubber, electric mixer, bursley, toothed scraper, rugged plastic bucket, horizontal feet, plastic cross, rubber hammer, etc.

2, the base is clean

When the tool is prepared, we need to clean up the base surface. The base requirement is to be flat and sturdy, can not have sand, cracks, scratches, uneven defects, and the base surface does not have dust, stains, etc. If the base is not flat, there is a stain, it is recommended that you should use a pick-up (loose base), pull-up (smooth base, etc.), a raised (loose base) or the flat treatment.

3, add water to stir well

When the base is cleaned, we need to stir it with water according to a certain ratio. The order of adding is: the first liquid, the specific proportion is: the ratio of tile rubber and water according to 20kg: 4.4-4.8L. Then we use the electric stirrer to stir well until there is no granular paste paste, and then stand for 10 minutes, after it is fully confirmed, it can be used normally. For the mixing slurry after stirring, it is recommended that everyone is used within 2-3 hours.

4, large area construction

粘瓷砖用什么胶最好 上海装修师傅分享怎么使用瓷砖胶

When it is mixed well, we need to spray the base surface with water, but it is necessary to have a moist but cannot have Mingshui. After that, we used tooth blade to apply tiles on the back of the wall and tiles. In scratch, we must ensure that the toothed scraper is consistent with the base surface, and each time it is applied to 1-2 square meters, then The tile can be pressed up to the porcelain brick, and fine tuning is performed within 15 minutes.

The above is the Shanghai installation network to everyone to share

as well as

Related content, pay attention to Shanghai to understand more renovation knowledge.

What kind of glue is best for stick porcelane bricks

What kind of glue is best for stick porcelane bricks

Type ceramic brick glue